Chevrolet Cobalt Service & Repair Manual: Hood Hinge

Chevrolet Cobalt Service & Repair Manual / Body & Frame / Hood Hinge

Removal

When a hood hold open device is being removed or installed, provide alternate support to avoid possibility of damage to vehicle or personal injury.
1. Open hood.
2. Place a suitable support between hood and air inlet grille panel.
3. Mark position of hood hinge using a grease pencil,.
4. Remove front fender as outlined in Front Fender.
5. Remove hinge bolts and hinge, Fig. 1.

Installation

1. Position hood hinge to alignment marks on vehicle, Fig. 1.
2. Install hood hinge to body bolts. Torque to 89 inch lbs.
3. Install front fender as outlined in Front Fender.
4. Remove hood to air inlet grille panel support.
5. Slowly lower hood.
6. Inspect hood alignment, and align hood as outlined in Hood.
7. Torque hinge to hood bolts to 89 inch lbs.
8. Close hood.

Fig. 1 Hood hinge bolts

    Hood
    Removal 1. Open and support hood. 2. Install a protective covering over fenders. 3. Remove hood insulator, ...

    Hood Primary & Secondary Latch
    Removal 1. Open hood. 2. Mark hood latch location to support bracket with a grease pencil. 3. Remove hood l ...

    See also:

    Chevrolet Cobalt Owners Manual. Safety Belt Use During Pregnancy
    Safety belts work for everyone, including pregnant women. Like all occupants, they are more likely to be seriously injured if they do not wear safety belts. A pregnant woman should wear a lap-shoulder belt, and the lap portion should be worn as low as possible, below the rounding, throughout ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2024 www.cheviguide.com - Chevrolet Auto Manuals - 0.0033