Chevrolet Cobalt Service & Repair Manual: Relearn
Initialization Sequence
| The EBCM performs one initialization test each ignition cycle. The initialization of the EBCM occurs when the EBCM detects the there is a minimum of 500 RPM from the ECM by means of a serial data message and the stop lamp switch is not applied. The initialization of the EBCM will also occur the vehicle speed is greater than 10 MPH and the stop lamp switch is applied. The initialization sequence may also be commanded with a scan tool. |
| The Initialization sequence cycles each solenoid valve and the pump motor as well as the required relays for approximately 1.5 seconds to check component operation. The EBCM sets a DTC if and error is detected. The initialization sequence may be heard and felt while it is taking place and is considered part of normal system operation. The EBCM defines a drive cycle as the completion of the initialization sequence. |
Operation
The desired yaw rate is calculated
from the position of the steering wheel, the speed of the vehicle and the
lateral, or sideways acceleration of the vehicle. The difference between
...
See also:
Chevrolet Cobalt Owners Manual. Safety Belt Reminders
Driver Safety Belt Reminder Light
When the engine is started, a chime sounds for
several seconds to remind a driver to fasten the safety
belt, unless the driver safety belt is already buckled.
The safety belt light
comes on and stays on
for several seconds, then
flashes for several more.
T ...
Chevrolet Cobalt Owners Manual
- In Brief
- Seats and Restraint System
- Features and Controls
- Instrument Panel
- Driving Your Vehicle
- Service and Appearance Care
- Maintenance Schedule
- Customer Assistance Information
Chevrolet Cobalt Service Manual
- Air Bags
- Air Conditioning & Heater
- Body & Frame
- Brakes
- Cooling System
- Driveline
- Electrical
- Electronic Stability Controls
- Engine Service
Copyright © 2024 www.cheviguide.com - Chevrolet Auto Manuals - 0.0032