Chevrolet Cobalt Service & Repair Manual: Compressor, Replace
| 1. |
Evacuate system as outlined under "Refrigerant
Recovery" in "General Service" on main menu selection. |
| 2. |
Raise and support the vehicle. |
| 3. |
Remove righthand front fender inner
liner screws and pin type retainers, then the liner. |
| 4. |
Rotate drive belt tensioner counterclockwise
to release tensioner spring tension. |
| 6. |
Disconnect A/C compressor electrical
connector. |
| 7. |
Remove A/C compressor hoses from compressor,
Fig. 1, then seal hose opening. |
| 8. |
Remove and discard sealing washers. |
| 9. |
Remove compressor mounting bolts,
Fig. 2, then the compressor. |
| 10. |
Reverse procedure to install, noting
the following: |
| |
a. |
Torque compressor hoses to 12-15
ft. lbs. |
| |
b. |
Torque compressor mounting bolts
to 18 ft. lbs. |
|
Fig. 1 A/C compressor hoses & seal removal
Fig. 2 Exploded view of compressor replacement
1.
Evacuate system as outlined under "Refrigerant
Recovery" in "General Service" on main menu selection.
2.
Remove hi ...
See also:
Chevrolet Cobalt Service & Repair Manual. Wheel, Replace
Removal
Caution: Never use heat to
loosen a tight wheel. This can shorten the life of wheel and damage wheel
bearings.
Wear approved safety glasses when
performing the following service procedures.
Do not use power grinders to clean
any of the brake ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Compressor Pressure Relief Valve, Replace
Cooling Fan