Chevrolet Cobalt Service & Repair Manual: Component Replacement

Chevrolet Cobalt Service & Repair Manual / Brakes / Hydraulic Brake Systems / Component Replacement

Master Cylinder

1. On Vibe models, remove air filter hose clamp and hose from throttle body.
2. On all models, disconnect fluid level sensor retainer and electrical connector.
3. Drain master cylinder reservoir brake fluid into suitable container.
4. Plug hose.
5. Disconnect master cylinder brake pipes. Plug open pipes.
6. Remove mounting nuts and master cylinder.
7. Remove reservoir, as required.
8. Reverse procedure to install. Bleed hydraulic system as outlined in Brake System Bleed.
    Brake System Bleed
    Brake fluid is corrosive to painted surfaces. Care must be taken not to allow brake fluid to come in contact with painted surfaces on vehicle. When bleeding the brake syste ...

    Component Service
    Master Cylinder Overhaul Impala Disassemble Refer to Figs. 1 and 2, when performing the following procedures. 1. Disconnect and plug hydraulic lines. ...

    See also:

    Chevrolet Cobalt Owners Manual. Preface
    GENERAL MOTORS, GM, the GM Emblem, CHEVROLET, the CHEVROLET Emblem, and the name COBALT are registered trademarks of General Motors. This manual describes features that may or may not be on your specific vehicle either because they are options that you did not purchase or due to changes sub ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2024 www.cheviguide.com - Chevrolet Auto Manuals - 0.0039