Chevrolet Cobalt Service & Repair Manual: Belt Tension Data
Removal
2. |
Bring engine to operating temperature. |
4. |
Read belt tension using belt tension
gauge tool No. J23600B, or equivalent, halfway between alternator
and power steering pump. |
5. |
Start engine and allow temperature
to stabilize for 15 seconds. |
7. |
Install 15mm socket, apply clockwise
force to tensioner pulley bolt. |
8. |
Release force and measure belt tension
without disturbing tensioner position. |
9. |
Install 15mm socket, apply counterclockwise
force to tensioner pulley bolt and raise pulley to eliminate tension. |
10. |
Slowly lower pulley to belt and measure
belt tension without disturbing tensioner position. |
11. |
Average out readings. |
12. |
If average is less than 30-50 lbs.,
replace belt tensioner. |
|
1.
Remove the balance shaft bearing carrier
bolts, Fig. 1.
2.
Remove the balance shaft assemblies.
3.
Instal ...
Removal
1.
Loosen vent hose clamp at air cleaner
resonator, air cleaner intake duct clamp at air cleaner outlet resonator.
2.
Loosen air ...
See also:
Chevrolet Cobalt Owners Manual. Driving in Rain and on Wet Roads
WARNING:
Wet brakes can cause crashes. They might not
work as well in a quick stop and could cause
pulling to one side. You could lose control of the
vehicle.
After driving through a large puddle of water or a
car/vehicle wash, lightly apply the brake pedal
until the brakes work normally.
Fl ...