Chevrolet Cobalt Service & Repair Manual: Rack & Pinion Assembly, Replace

1. Ensure front wheels are in straight ahead position, then secure steering wheel to prevent rotation.
2. Raise and support vehicle, then remove wheel and tire assemblies.
3. Remove steering gear to intermediate shaft pinch bolt. Discard bolt.
4. Separate steering gear from intermediate shaft.
5. Remove attaching nut from outer tie rod ball stud.
6. Remove outer tie rod ball stud from steering knuckle using ball joint separator tool No. J24319-B, or equivalent.
7. Remove steering gear mounting bolts.
8. Remove rear transaxle mount.
9. Remove steering gear from frame, then from vehicle through lefthand wheel opening.
10. Reverse procedure to install.
    Power Steering System Leak, Inspection
    Most modern cars come equipped with hydraulic power steering, as systems age they can wear out. Power steering fluid leaks (depending on severity) will cause the power steering system ...

    Shock Absorber, Replace
    Rear 1. Raise and support vehicle, then remove tire and wheel assembly. 2. Support rear axle with a suitable jack stand. ...

    See also:

    Chevrolet Cobalt Service & Repair Manual. Relearn
    Initialization Sequence The EBCM performs one initialization test each ignition cycle. The initialization of the EBCM occurs when the EBCM detects the there is a minimum of 500 RPM from the ECM by means of a serial data message and the stop lamp switch is not applied. The initial ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual

    Copyright © 2022 - Chevrolet Auto Manuals - 0.0039