Chevrolet Cobalt Service & Repair Manual: Stabilizer Bar Link Kit R&R

Refer to Fig. 1 when performing the following procedure.
1. Raise and support the vehicle.
2. Remove the front tire and wheel assembly.
3. Remove front stabilizer shaft link nut to strut.
4. Remove front stabilizer shaft link nut to bar.
5. Remove front stabilizer shaft link.
6. Reverse procedure to install, noting the following:
  a. Torque front stabilizer shaft link nut to strut to 48 ft. lbs.
  b. Torque front stabilizer shaft link nut to bar to 59 ft. lbs.

Fig. 1 Stabilizer shaft link replacement

    Shock Absorber, Replace
    Rear 1. Raise and support vehicle, then remove tire and wheel assembly. 2. Support rear axle with a suitable jack stand. ...

    Stabilizer Bar, Replace
    Front 1. Raise and support vehicle, then remove tire and wheel assemblies. 2. Remove rear transaxle mount. 3. ...

    See also:

    Chevrolet Cobalt Service & Repair Manual. Wheel, Replace
    Removal Caution: Never use heat to loosen a tight wheel. This can shorten the life of wheel and damage wheel bearings. Wear approved safety glasses when performing the following service procedures. Do not use power grinders to clean any of the brake ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2024 www.cheviguide.com - Chevrolet Auto Manuals - 0.0034