Chevrolet Cobalt Service & Repair Manual: Stabilizer Bar, Replace

Front

1. Raise and support vehicle, then remove tire and wheel assemblies.
2. Remove rear transaxle mount.
3. On models equipped with soft or sport suspensions, remove steering gear assembly.
4. On all models, remove lower stabilizer shaft link retaining nuts.
5. Remove front stabilizer shaft clamps, then the shaft insulators.
6. Remove stabilizer shaft from vehicle.
7. Reverse procedure to install, noting the following:
  a. Torque transmission mount through bolt to 74 ft. lbs.
  b. Torque steering gear mounting bolts to 81 ft. lbs.
  c. Torque stabilizer link to strut nuts to 48 ft. lbs.
  d. Torque stabilizer shaft clamp to 37 ft. lbs.
  e. Torque stabilizer shaft link to stabilizer bar to 59 ft. lbs.
    Stabilizer Bar Link Kit R&R
    Refer to Fig. 1 when performing the following procedure. 1. Raise and support the vehicle. 2. Remove the front tire and wheel ...

    Stabilizer Bushing R&R
    Refer to Fig. 1 when performing the following procedure. 1. Raise and support the vehicle. 2. Remove front stabilizer shaft cl ...

    See also:

    Chevrolet Cobalt Service & Repair Manual. Heater Hose, Replace
    Inlet 1. Drain coolant into a suitable container. 2. Loosen hose clamp connecting hose to heater core inlet tube. 3. Loosen hose clamp connecting hose to water pump bypass tube. ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2024 www.cheviguide.com - Chevrolet Auto Manuals - 0.0039