Chevrolet Cobalt Service & Repair Manual: Brake Light Switch R&R
Refer to Fig. 1
when performing following procedure. |
1. |
Remove lefthand front wheel. |
2. |
Disconnect back-up lamp connector (1). |
3. |
Remove back-up lamp switch assembly. |
4. |
Reverse procedure to install. Torque
back-up lamp switch to 24 ft. lbs. |
|
Fig. 1 Brake light switch replacement
Refer to Fig. 1.
when performing the following procedure.
1.
Remove brake fluid indicator switch
connector.
2.
Remove br ...
1.
Remove driver's instrument panel knee
bolster.
2.
Disconnect clutch start switch electrical
connector.
...
See also:
Chevrolet Cobalt Service & Repair Manual. Relearn
Initialization Sequence
The EBCM performs one initialization
test each ignition cycle. The initialization of the EBCM occurs when the
EBCM detects the there is a minimum of 500 RPM from the ECM by means of
a serial data message and the stop lamp switch is not applied. The initial ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual