Chevrolet Cobalt Service & Repair Manual: Ignition Switch, Replace

Chevrolet Cobalt Service & Repair Manual / Electrical / Component Replacement / Ignition Switch, Replace

1. Remove steering column trim covers.
2. Disconnect ignition switch harness connector.
3. Turn ignition switch to Run position.
4. Remove ignition switch screws, then ignition switch from steering column, Fig. 1.
5. Reverse procedure to install.

Fig. 1 Ignition switch replacement

    Ignition Lock, Replace
    1. Lower steering column to lowest position. 2. Remove steering column upper and lower trim covers. 3. Remov ...

    Malfunction Indicator Lamp, Diagnosis & Testing
    The Malfunction Indicator Lamp (MIL) is located on the Instrument Panel Cluster (IPC). The MIL informs the driver that an emission system fault has occurred and that the engine cont ...

    See also:

    Chevrolet Cobalt Service & Repair Manual. Steering Knuckle, Replace
    1. Raise and support vehicle using suitable lift. 2. Remove tire and wheel assemblies. 3. Separate outer tie rod end from steering knuckle using suitable tool. 4. Disconnect ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2024 www.cheviguide.com - Chevrolet Auto Manuals - 0.0031