Chevrolet Cobalt Service & Repair Manual: Multi-Function Switch, Replace
| 1. |
Remove steering column trim covers. |
| 2. |
Remove multi-function switch retaining
screws. |
| 3. |
Disconnect multi-function switch electrical
connector, then remove switch from column. |
| 4. |
Reverse procedure to install. |
|
The Malfunction Indicator Lamp
(MIL) is located on the Instrument Panel Cluster (IPC). The MIL informs
the driver that an emission system fault has occurred and that the engine
cont ...
1.
Apply parking brake and place control
assembly in Neutral. Transaxle manual shaft must be in Neutral position
prior to installing range switch.
...
See also:
Chevrolet Cobalt Service & Repair Manual. Troubleshooting
When troubleshooting the hydraulic
brake system, perform the following inspections.
Master Cylinder Internal Fluid Leakage Check
Start engine and depress the brake
pedal. If the pedal gradually falls under constant pressure, the hydraulic
system may be leaking. Raise ...
Malfunction Indicator Lamp, Diagnosis & Testing
Neutral Safety Switch, Replace