Chevrolet Cobalt Service & Repair Manual: Windshield Washer Switch R&R
| Refer to Fig. 1
when performing following procedure. |
| 1. |
Remove instrument panel center trim
panel. |
| 2. |
Remove steering column trim covers,
Fig. 2. |
| 3. |
Remove windshield wiper and washer
switch, then disconnect electrical connectors. |
| 4. |
Reverse procedure to install. Torque
steering column trim cover bolt to 18 inch lbs. |
|
Fig. 1 Windshield wiper and washer switch replacement
Fig. 2 Steering column trim replacement
1.
Disconnect washer hose clip at righthand
front fender flange.
2.
Disconnect washer pump hose from windshield
washer hose at righ ...
Removal
1.
Turn ignition ON.
2.
Turn wiper switch to DELAY.
3.
Turn ignition OFF when wiper arms are
paused ...
See also:
Chevrolet Cobalt Service & Repair Manual. Relearn
Initialization Sequence
The EBCM performs one initialization
test each ignition cycle. The initialization of the EBCM occurs when the
EBCM detects the there is a minimum of 500 RPM from the ECM by means of
a serial data message and the stop lamp switch is not applied. The initial ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Windshield Washer Fluid Reservoir, Replace
Windshield Wiper Arm, Replace