Chevrolet Cobalt Service & Repair Manual: Compression Pressures

Chevrolet Cobalt Service & Repair Manual / Engine Management / Engine Tune Up & Performance / Compression Pressures

1. Ensure engine is at room temperature and battery is fully charged.
2. Disconnect wiring from ignition module and remove spark plugs.
3. Throttle body valve should be wide open.
4. Install a suitable compression gauge into No. 1 spark plug opening and crank engine through four compression strokes.
5. Lowest reading cylinder should not be less than 70 percent of highest and no cylinder reading should be less than 100 psi.
6. Repeat compression test procedures for remaining three cylinders.
7. Remove compression gauge from engine, then install spark plugs and engine cover.
    Engine Tune Up & Performance
    ...

    Idle Speed & Mixture Adjustments
    Idle speed is controlled by the ECM/PCM. No adjustment is required. Curb Idle Speed Curb idle speed is controlled by the ECM/PCM. No adjustment is required. Fast Idl ...

    See also:

    Chevrolet Cobalt Owners Manual. Antilock Brake System (ABS) Warning Light
    For vehicles with the Antilock Brake System (ABS), this light comes on briefly when the engine is started. If it does not, have the vehicle serviced by your dealer/retailer. If the system is working normally the indicator light then goes off. If the ABS light stays on, turn the ignition of ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2024 www.cheviguide.com - Chevrolet Auto Manuals - 0.0044