Chevrolet Cobalt Service & Repair Manual: Rear Compartment Lid Hinge
Removal
1. |
Raise and support rear compartment
lid. |
2. |
Remove compartment lid hinge bolts
(2), Fig. 1.from hinge. |
3. |
Remove compartment lid hinge nuts (1)
from decklid studs. |
4. |
Remove compartment lid hinge (3) from
vehicle. |
|
Installation
1. |
Position rear compartment lid hinge
(3) to vehicle, Fig. 1. |
2. |
Install rear compartment hinge nuts
(1) to studs on decklid. Torque nuts to 89 inch lbs. |
3. |
Install rear compartment hinge bolts
(2) to hinge. Torque bolts to 89 inch lbs. |
4. |
Adjust rear compartment lid if required
as outlined in Rear Compartment Lid. |
|
Fig. 1 Rear compartment lid hinges
Removal
1.
Open rear compartment lid (2).
2.
Remove rear spoiler, if equipped.
3.
Remove rear lock cylinder.
...
Removal
1.
Release lock rod using a flat-bladed
tool.
2.
Disconnect electrical connector if
equipped.
3.
...
See also:
Chevrolet Cobalt Service & Repair Manual. Relearn
Initialization Sequence
The EBCM performs one initialization
test each ignition cycle. The initialization of the EBCM occurs when the
EBCM detects the there is a minimum of 500 RPM from the ECM by means of
a serial data message and the stop lamp switch is not applied. The initial ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual