Chevrolet Cobalt Service & Repair Manual: Engine Oil Pump Pickup R&R
| On some models oil pump pickup
can not be removed from pump. Pickup must be replaced with oil pump as a
unit. |
| It is recommended to change oil
filter when replacing oil pump pickup. |
| 1. |
Lift and support vehicle using a suitable
lift. |
| 2. |
Drain engine oil from oil pan. |
| 3. |
Remove oil pan from engine. |
| 4. |
Remove any pickup support bracket fasteners
if equipped. |
| 5. |
Remove pickup mounting fasteners to
oil pump. |
| 6. |
Remove oil pump pickup from pump. |
| 7. |
Reverse procedure to install, note
following: |
| |
a. |
Fill engine oil to specified level. |
| |
b. |
Run engine at idle for approximately
30 seconds and turn OFF. |
| |
c. |
Ensure engine oil is still at specified
level. |
|
1.
Install the engine support fixture.
2.
Remove the engine mount.
3.
Raise the engine enough to allow clearance
...
Cylinder Head, Valve Guide, & Valve Seat
All Measurements Given In Inches
Unless Otherwise Specified
Engine (VIN) 1
Year
Cylind ...
See also:
Chevrolet Cobalt Service & Repair Manual. Back-Up Lamp Bulb, Replace
Coupe
Warning: Halogen bulbs contain
gas under pressure. Handling a bulb improperly could cause it to shatter
into flying glass fragments. To help avoid personal injury: Turn off the
lamp switch and allow the bulb to cool before changing the bulb. Leave the
lamp switch OFF un ...
Engine Oil Pan Gasket R&R
Engine Rebuild Specifications