Chevrolet Cobalt Service & Repair Manual: Valve Cover, Replace

Removal

1. Loosen vent hose clamp at air cleaner resonator, air cleaner intake duct clamp at air cleaner outlet resonator.
2. Loosen air cleaner outlet resonator to throttle body clamp, located forward of accelerator cable bracket. Remove air cleaner resonator to accelerator bracket bolt.
3. Remove throttle body resonator, air cleaner intake duct and vent hose.
4. Disconnect accelerator and cruise control cables from throttle body, then the bracket.
5. Remove PCV valve.
6. Remove fuel line brackets and brake booster hose pipe from brackets.
7. Remove mounting screw, ignition coil and Ignition Control Module (ICM).
8. Remove ground strap.
9. Remove mounting bolts and camshaft cover.
10. Reverse procedure to install.
    Valve Cover Gasket R&R
    1. Remove the intake manifold cover. 2. Remove the air cleaner outlet duct. 3. Disconnect the intake (3) and exhau ...

    Valve Spring Replace
    This procedure is designed to replace valve spring while head is attached to engine. 1. Install a suitable flywheel holding tool in order to prevent ...

    See also:

    Chevrolet Cobalt Owners Manual. Turn Signal/Multifunction Lever
    The lever on the left side of the steering column operates the following: : Turn and Lane-Change Signals : Headlamp High/Low-Beam Changer : Exterior Lamp Control Flash-to-Pass. Information for these features is on the pages following. ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright В© 2020 www.cheviguide.com - Chevrolet Auto Manuals - 0.0113