Chevrolet Cobalt Owners Manual: Back-Up Lamps (Coupe)
To replace a back-up lamp bulb: 1. Open the trunk. See Trunk.
2. Locate the back-up lamp bulb assembly in the trunk lid.
3. Turn the bulb socket counterclockwise and pull it out of the lamp assembly.
On vehicles that have a back-up lamp cover, first remove it by pressing the tab at the top.
4. Pull the old bulb straight out of the bulb socket.
5. Push the new bulb straight into the bulb socket until it clicks.
6. Push the bulb socket into the lamp assembly and turn it clockwise to lock it into place.
Taillamps, Turn Signal, Stoplamps and Back-up Lamps (Sedan)
To replace one of these bulbs:
1. Open the trunk.
2. Remove the trunk trim and pull back fastener.
3. Remove the additional fastener.
4. Remove the outer two screws from the taillamp
assembly.
5 ...
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws holding each of the
license plate lamps.
2. Turn and pull the license plate lamp toward you
through the opening.
3. Turn the bulb socket ...
See also:
Chevrolet Cobalt Service & Repair Manual. Rear Compartment Lid Latch
Removal
1.
Release lock rod using a flat-bladed
tool.
2.
Disconnect electrical connector if
equipped.
3.
Remove rear compartment latch bolts
(2), Fig. 1.
4.
Remove la ...
Chevrolet Cobalt Owners Manual
- In Brief
- Seats and Restraint System
- Features and Controls
- Instrument Panel
- Driving Your Vehicle
- Service and Appearance Care
- Maintenance Schedule
- Customer Assistance Information
Chevrolet Cobalt Service Manual
- Air Bags
- Air Conditioning & Heater
- Body & Frame
- Brakes
- Cooling System
- Driveline
- Electrical
- Electronic Stability Controls
- Engine Service
