Chevrolet Cobalt Service & Repair Manual: Emission Control Service Reminder Indicators (SRI) Reset Procedures

Chevrolet Cobalt Service & Repair Manual / Engine Management / Emission Controls / Emission Control Service Reminder Indicators (SRI) Reset Procedures

Change Oil, Change Oil Now Or Change Oil Soon Messages

After changing the engine oil, the system must be reset as follows:
1. Turn ignition to RUN with engine off.
2. Press INFORMATION and RESET buttons on Driver Information Center (DIC) at same time to enter personalization menu.
3. Press INFORMATION button to scroll through available personalization menu modes until DIC display shows: OIL LIFE RESET.
4. Press and hold RESET button until DIC display shows ACKNOWLEDGED.
5. This will tell you system has been reset. Turn key to LOCK.
    EGR Functional Tests
    Fuel Injected Gasoline Engine The EGR systems used on fuel injected engines are controlled by the ECM. The ECM will store a code in memory when the EGR system malfunctions. Refer to ap ...

    Engine Liters/ CID/ Type
    SFI/OBD II system. Equipped w/MIL. Engine Liters/ CID/ Type Certif- ication Type Trans. Type ...

    See also:

    Chevrolet Cobalt Service & Repair Manual. Hood Support Strut, Replace
    Warning: Body injury may occur if no supporting rod is holding hood open when removing hood support strut. Apply pressure only at end of hood assist rod for removal or installation. Do not apply pressure to middle of rod because damage or bending will result. ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2026 www.cheviguide.com - Chevrolet Auto Manuals - 0.3676