Chevrolet Cobalt Service & Repair Manual: Engine Oil Pan Gasket R&R
1. |
Install the engine support fixture. |
2. |
Remove the engine mount. |
3. |
Raise the engine enough to allow clearance
for the oil pan removal. |
4. |
Raise and support the vehicle. |
5. |
Place a drain pan under the oil pan
drain plug. |
6. |
Remove the oil pan drain plug. |
8. |
Remove the engine drive belt. |
9. |
Remove the lower AC compressor bolt
and loosen the upper bolts. |
10. |
Remove the four oil pan to transaxle
bolts (1), Fig. 1. |
11. |
Remove the oil pan bolts. |
12. |
Remove the oil pan, Fig.
1. |
13. |
Remove any old oil pan sealant (1),
Fig. 1. |
14. |
Reverse procedure to install, noting
the following: |
|
a. |
Ensure that the oil pan and the sealing
surface (1) on the lower crankcase are free of all oil and debris,
Fig. 1. |
|
b. |
Apply a 3.5 mm bead of sealant around
the perimeter of the oil pan and the oil suction port opening. DO
NOT over apply the sealant. |
|
c. |
Install the oil pan bolts and oil pan
in sequence shown, Fig. 2. |
|
d. |
Torque transaxle bolts to 55
ft. lbs. |
|
e. |
Torque oil pan bolts to 18 ft.
lbs. |
|
Fig. 1 Oil pan replacement
Fig. 2 Oil pan bolt sequence
Refer to Fig. 1
when performing the following procedure.
1.
Place a collecting pan underneath the
oil filter.
2.
Use too ...
On some models oil pump pickup
can not be removed from pump. Pickup must be replaced with oil pump as a
unit.
It is recommended to change oil
filter when replacing oil ...
See also:
Chevrolet Cobalt Owners Manual. Remote Vehicle Start
With this feature the engine can be started from outside
of the vehicle.
Starting the Vehicle
1. Aim the RKE transmitter at the vehicle.
2. Press .
3. Immediately after completing Step 2, press and
hold until the turn signal
lamps flash.
When the vehicle starts, the parking lamps will turn ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual