Chevrolet Cobalt Service & Repair Manual: Engine Oil Pump Pickup R&R
| On some models oil pump pickup
can not be removed from pump. Pickup must be replaced with oil pump as a
unit. |
| It is recommended to change oil
filter when replacing oil pump pickup. |
| 1. |
Lift and support vehicle using a suitable
lift. |
| 2. |
Drain engine oil from oil pan. |
| 3. |
Remove oil pan from engine. |
| 4. |
Remove any pickup support bracket fasteners
if equipped. |
| 5. |
Remove pickup mounting fasteners to
oil pump. |
| 6. |
Remove oil pump pickup from pump. |
| 7. |
Reverse procedure to install, note
following: |
| |
a. |
Fill engine oil to specified level. |
| |
b. |
Run engine at idle for approximately
30 seconds and turn OFF. |
| |
c. |
Ensure engine oil is still at specified
level. |
|
1.
Install the engine support fixture.
2.
Remove the engine mount.
3.
Raise the engine enough to allow clearance
...
Cylinder Head, Valve Guide, & Valve Seat
All Measurements Given In Inches
Unless Otherwise Specified
Engine (VIN) 1
Year
Cylind ...
See also:
Chevrolet Cobalt Service & Repair Manual. Description & Operation
The SIR system helps supplement
the protection offered by the driver and front passenger seat belts by deploying
air bag module from the center of steering wheel, passenger's instrument
panel, front and rear sides of seats and from the sides of the roof panel.
The air bags ...
Engine Oil Pan Gasket R&R
Engine Rebuild Specifications