Chevrolet Cobalt Service & Repair Manual: Valve Cover Gasket R&R
| 1. |
Remove the intake manifold cover. |
| 2. |
Remove the air cleaner outlet duct. |
| 3. |
Disconnect the intake (3) and exhaust
(2) camshaft position actuator solenoid valve electrical connectors,
Fig. 1. |
| 4. |
Remove the ignition coils. |
| 5. |
Remove the engine harness clips (1,
2) from the cover, Fig. 2. |
| 6. |
Remove the fuel feed line retainers
(1, 2) from the engine brackets, Fig. 3. |
| 7. |
Remove the camshaft cover bolts,
Fig. 4. |
| 8. |
Remove the camshaft cover. |
| 9. |
Reverse procedure to install, noting
the following: |
| |
a. |
Torque camshaft cover bolts
to 89 inch lbs. |
| |
b. |
Torque ignition coil bolts to
89 inch lbs. |
| |
c. |
Torque air cleaner and throttle
body clamps to 44 inch lbs. |
|
Fig. 1 Camshaft position solenoid valve connector
Fig. 2 Engine harness replacement
Fig. 3 Fuel feed line retainer replacement
Fig. 4 Camshaft cover replacement
Year
Component
Torque, Ft. Lbs.
2009-10
Accelerator & Cruise Control Cable
89 2
A ...
Removal
1.
Loosen vent hose clamp at air cleaner
resonator, air cleaner intake duct clamp at air cleaner outlet resonator.
2.
Loosen air ...
See also:
Chevrolet Cobalt Owners Manual. Taillamps and Turn Signal Lamps (Coupe)
To replace this bulb:
1. Open the trunk.
2. Remove the trunk trim and pull back fastener.
3. Disconnect the wiring harness by lifting up on the
tab to release and pull it straight out.
4. Turn the bulb socket counterclockwise and pull it
straight out of the taillamp assembly.
5. Pull the ol ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Tightening Specifications
Valve Cover, Replace