Chevrolet Cobalt Service & Repair Manual: Window Regulator R&R

Chevrolet Cobalt Service & Repair Manual / Interior Panels / Window Regulator R&R

Front

Coupe

Manual
1. Remove interior trim panel.
2. Remove water deflector.
3. Move window to full up position and secure in place with tape.
4. Remove side door window regulator nut, Fig. 1.
5. Remove side door window regulator bolts, Fig. 1.
6. Remove front side door window regulator assembly, Fig. 1.
7. Reverse procedure to install. Torque window regulator fasteners to 89 inch lbs.
Power
1. Remove interior trim panel.
2. Remove water deflector.
3. Move window to full up position and secure in place with tape.
4. Remove side door window regulator nut, Fig. 2.
5. Remove side door window regulator bolts, Fig. 2.
6. Disconnect electrical connector.
7. Remove front side door window regulator assembly, Fig. 2.
8. Reverse procedure to install. Torque window regulator fasteners to 89 inch lbs.

Sedan

Manual
1. Remove interior trim panel.
2. Remove water deflector.
3. Move window to full up position and secure in place with tape.
4. Remove side door window regulator bolts, Fig. 3.
5. Remove front side door window regulator assembly, Fig. 3.
6. Reverse procedure to install. Torque window regulator bolts to 89 inch lbs.
Power
1. Remove interior trim panel.
2. Remove water deflector.
3. Move window to full up position and secure in place with tape.
4. Remove side door window regulator bolts, Fig. 4.
5. Disconnect electrical connector.
6. Remove front side door window regulator assembly, Fig. 4.
7. Reverse procedure to install. Torque window regulator bolts to 89 inch lbs.

Rear

Manual

Loosen bolts enough so that regulator assembly will lift out of T-slots in door inner panel.
1. Remove interior trim panel.
2. Remove water deflector.
3. Move window to full up position and secure in place with tape.
4. Remove side door window regulator bolts, Fig. 5.
5. Remove rear side door window regulator assembly, Fig. 5.
6. Reverse procedure to install. Torque rear window regulator bolts to 89 inch lbs.

Power

Loosen bolts enough so that regulator assembly will lift out of T-slots in door inner panel.
1. Remove interior trim panel.
2. Remove water deflector.
3. Move window to full up position and secure in place with tape.
4. Remove side door window regulator bolts, Fig. 6.
5. Disconnect electrical connector.
6. Remove rear side door window regulator assembly, Fig. 6.
7. Reverse procedure to install. Torque rear window regulator bolts to 89 inch lbs.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

    Liftgate Lock Cylinder R & R
    Refer to Fig. 1 when performing the following procedure. 1. Remove lock cylinder rod. 2. Remove lock cylinder retainer clip. ...

    Window Regulator, Overhaul
    1. Remove door trim panel as outlined in "Door Trim Panel." 2. Remove window regulator as outlined in "Window Regula ...

    See also:

    Chevrolet Cobalt Owners Manual. Checking the Restraint Systems
    Safety Belts Now and then, check that the safety belt reminder light, safety belts, buckles, latch plates, retractors, and anchorages are all working properly. Look for any other loose or damaged safety belt system parts that might keep a safety belt system from doing its job. See your dealer/ ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2026 www.cheviguide.com - Chevrolet Auto Manuals - 0.2752