Chevrolet Cobalt Service & Repair Manual: Blower Motor Relay R & R
| Refer to Fig. 1
when performing the following procedure. |
| 1. |
Disconnect the blower motor resistor
electrical connector. |
| 2. |
Unsnap the blower motor resistor from
the HVAC module and remove. |
| 3. |
Reverse procedure to install. |
|
Fig. 1 Blower motor relay replacement
Refer to Fig. 1
for ambient air temperature sensor service.
Fig. 1 ...
Warning: To avoid being burned,
do not remove the radiator cap or surge tank cap while the engine is hot.
The cooling system will release scalding fluid and steam under pressure
if ...
See also:
Chevrolet Cobalt Service & Repair Manual. Battery Cable, Replace
Ground Cable
Battery To Battery Tray
Caution: Unless directed otherwise,
the ignition and start switch must be in the OFF or LOCK position, and all
electrical loads must be OFF before servicing any electrical component.
Disconnect the battery ground to prevent an electrical spar ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Ambient Air Temperature Sensor R&R
Coolant Drain, Flush & Refill