Chevrolet Cobalt Service & Repair Manual: Rotor Replace
Cobalt & Malibu
| 1. |
Raise and support vehicle, then remove
tire and wheel assembly. |
| 2. |
Compress piston into caliper bore using
suitable C-clamp to allow caliper pivot upward from brake pads. |
| 3. |
Install and tighten two wheel nuts
opposite to retain rotor to hub. |
| 4. |
Remove guide pin bolts, caliper and
bracket. |
| 5. |
Mark rotor to wheel studs for installation
alignment and remove rotor. |
| 6. |
Reverse procedure to install. |
|
Camaro
| 1. |
Raise and support vehicle. |
| 2. |
Remove tire and wheel assembly. |
| 3. |
Remove and discard disc brake caliper
bracket bolts.Disc brake caliper bracket bolts must be replaced
any time they are removed. Do not reuse disc brake caliper bracket
bolts. |
| 4. |
Remove disc brake caliper and bracket
assembly and support with heavy mechanics wire or equivalent. |
| 5. |
Remove disc brake rotor bolt. |
| 6. |
Remove disc brake rotor. |
| 7. |
Reverse procedure to install. |
|
Parking Brake Equalizer Cable, Replace
1.
Remove center console.
2.
Remove adjuster nut and cables from
equalizer, Fig. 1.
...
Year
Component
Torque Ft. Lbs.
CAMARO
2010
Brake Rotor Bolt
89 1
Calip ...
See also:
Chevrolet Cobalt Service & Repair Manual. Pinpoint Test
Ensure battery voltage is greater
than 12 volts prior to and during pinpoint test.
Caution: Do not have a battery
charger attached during vehicle testing.
Warning: Never use electrical
test equipment on any circuit related to the SRS unless instructed by ...
Parking Brake Service
Tightening Specifications