Chevrolet Cobalt Service & Repair Manual: Component Replacement
Master Cylinder
| 1. |
On Vibe models, remove air filter
hose clamp and hose from throttle body. |
| 2. |
On all models, disconnect fluid
level sensor retainer and electrical connector. |
| 3. |
Drain master cylinder reservoir brake
fluid into suitable container. |
| 5. |
Disconnect master cylinder brake pipes.
Plug open pipes. |
| 6. |
Remove mounting nuts and master cylinder. |
| 7. |
Remove reservoir, as required. |
| 8. |
Reverse procedure to install. Bleed
hydraulic system as outlined in Brake System Bleed. |
|
Brake fluid is corrosive to painted
surfaces. Care must be taken not to allow brake fluid to come in contact
with painted surfaces on vehicle.
When bleeding the brake syste ...
Master Cylinder Overhaul
Impala
Disassemble
Refer to Figs. 1
and 2, when performing the following procedures.
1.
Disconnect and plug hydraulic lines.
...
See also:
Chevrolet Cobalt Service & Repair Manual. Precautions
1.
After disassembling power brake unit,
soak metal components in solvent.
2.
Use only alcohol on components containing
rubber. After components have been thoroughly cleaned and rinsed
in solvent, they should be washed again ...
Brake System Bleed
Component Service