Chevrolet Cobalt Service & Repair Manual: Wiper Transmission, Replace

Chevrolet Cobalt Service & Repair Manual / Electrical / Component Replacement / Wiper Transmission, Replace

1. Remove wiper arm assemblies.
2. Disconnect washer tubing from air inlet screen.
3. Remove air inlet grille panel push-in retainers from panel using door trim pad and garnish clip remover tool No. J-38778, or equivalent.
4. Remove air inlet grille panel from vehicle.
5. Remove wiper drive module.
6. Disconnect electrical connector from wiper motor.
7. Remove wiper transmission from wiper motor crank arm using wiper transmission separator tool No. J-39232, or equivalent.
8. Remove cap from wiper transmission.
9. Remove screws and wiper transmission from tube frame.
10. Reverse procedure to install, noting the following:
  a. Torque wiper transmission screws to 79 inch lbs.
  b. Torque wiper drive system module screws to 88 inch lbs.
    Wiper Switch, Replace
    1. Remove steering column trim covers. 2. Remove multi-function switch as outlined in "Multi-Function Switch, Replace." ...

    Starter & Alternator
    ...

    See also:

    Chevrolet Cobalt Owners Manual. Airbag Readiness Light
    The system checks the airbag's electrical system for possible malfunctions. If the light stays on it indicates there is an electrical problem. The system check includes the airbag sensor, the pretensioners, the airbag modules, the wiring and the crash sensing and diagnostic module. For more i ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2026 www.cheviguide.com - Chevrolet Auto Manuals - 0.0046