Chevrolet Cobalt Service & Repair Manual: Starter, Replace

Chevrolet Cobalt Service & Repair Manual / Electrical / Starter & Alternator / Starter, Replace

1. Disconnect battery ground cable from battery.
2. Raise and support vehicle.
3. Remove starter solenoid terminal nut.
4. Remove positive battery cable terminal from starter.
5. Remove starter solenoid wire terminal from starter.
6. Disconnect engine harness connector from starter.
7. Remove starter motor mounting bolts.
8. Remove starter from vehicle.
9. Reverse procedure to install, noting the following:
  a. Torque starter mounting bolts to 30 ft. lbs.
  b. Torque starter solenoid terminal nut to 13 ft. lbs.
    Alternator, Replace
    1. Disconnect battery ground cable from battery. 2. Remove accessory drive belt. 3. Remove engine harness al ...

    Electronic Stability Controls
    ...

    See also:

    Chevrolet Cobalt Service & Repair Manual. Tie Rod, Replace
    Front Outer 1. Raise and support vehicle using suitable lift. 2. Remove tire and wheel assemblies. 3. Remove nut from outer tie rod ball stud, loosen jam nut. 4. Remove ou ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2026 www.cheviguide.com - Chevrolet Auto Manuals - 0.33