Chevrolet Cobalt Owners Manual: Turn and Lane-Change Signals
An arrow on the
instrument panel cluster
flashes in the direction of
the turn or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is complete.
The lever returns to its starting position when it is released.
If after signaling a turn or a lane change the arrows flash rapidly or do not come on, a signal bulb could be burned out.
Have the bulbs replaced. If the bulb is not burned out, check the fuse. See Fuses and Circuit Breakers.
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
operates the following:
: Turn and Lane-Change Signals
: Headlamp High/Low-Beam
Changer
: Exterior Lamp Control
Flash-to-Pass.
Information ...
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to high beam,
push the turn signal lever away from you.
This indicator light
appears on the instrument
panel cluster when the
high beams are on.
To change ...
See also:
Chevrolet Cobalt Service & Repair Manual. Windshield Washer Switch R&R
Refer to Fig. 1
when performing following procedure.
1.
Remove instrument panel center trim
panel.
2.
Remove steering column trim covers,
Fig. 2.
3.
Remove windshield wiper and washer
...
Chevrolet Cobalt Owners Manual
- In Brief
- Seats and Restraint System
- Features and Controls
- Instrument Panel
- Driving Your Vehicle
- Service and Appearance Care
- Maintenance Schedule
- Customer Assistance Information
Chevrolet Cobalt Service Manual
- Air Bags
- Air Conditioning & Heater
- Body & Frame
- Brakes
- Cooling System
- Driveline
- Electrical
- Electronic Stability Controls
- Engine Service
