Chevrolet Cobalt Service & Repair Manual: Oil Pressure Switch R&R
| Refer to Fig. 1
when performing following procedure. |
| 1. |
Disconnect battery ground cable. |
| 2. |
Raise and support vehicle. |
| 3. |
Remove starter solenoid terminal nut. |
| 4. |
Remove positive battery cable terminal
from starter. |
| 5. |
Remove starter solenoid wire terminal
from starter. |
| 6. |
Disconnect engine harness connector
from starter. |
| 7. |
Remove starter bolts and starter,
Fig. 2. |
| 8. |
Disconnect engine wiring harness electrical
connector from oil pressure switch. |
| 9. |
Remove engine oil pressure switch. |
| 10. |
Reverse procedure to install, noting
the following: |
| |
a. |
Torque starter bolts to 30 ft.
lbs. |
| |
b. |
Torque starter solenoid terminal
nuts to 13 ft. lbs. |
|
Fig. 1 Oil pressure switch replacement
Fig. 2 Starter replacement
1.
Apply parking brake and place control
assembly in Neutral. Transaxle manual shaft must be in Neutral position
prior to installing range switch.
...
Ensure battery voltage is greater
than 12 volts prior to and during pinpoint test.
Caution: Do not have a battery
charger attached during vehicle testing.
Warn ...
See also:
Chevrolet Cobalt Owners Manual. Outside Power Mirrors
Controls for the outside
power mirrors are
located on the driver
door armrest.
To adjust the mirrors:
1. Move the selector switch located below the
four-way control pad to the left or right to choose
either the driver or passenger side mirror.
2. Press one of the four arrows located on the c ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Neutral Safety Switch, Replace
Pinpoint Test