Chevrolet Cobalt Service & Repair Manual: Neutral Safety Switch, Replace
| 1. |
Apply parking brake and place control
assembly in Neutral. Transaxle manual shaft must be in Neutral position
prior to installing range switch. |
| 2. |
Remove shift control cable from transaxle
range switch lever. |
| 3. |
Disconnect electrical connectors from
transaxle range switch. |
| 4. |
Remove transaxle range switch lever
nut and lever. |
| 5. |
Remove transaxle range switch bolts,
then the switch. |
| 6. |
Reverse procedure to install, noting
the following: |
| |
a. |
Install transaxle range switch alignment
tool No. J-41545, or equivalent over shaft and switch. |
| |
b. |
Rotate switch until alignment tool
drops into position. |
| |
c. |
Torque switch bolts to 15 ft.
lbs. |
|
1.
Remove steering column trim covers.
2.
Remove multi-function switch retaining
screws.
3.
Disconnect multi ...
Refer to Fig. 1
when performing following procedure.
1.
Disconnect battery ground cable.
2.
Raise and support vehicle.
...
See also:
Chevrolet Cobalt Service & Repair Manual. Pinpoint Test
Ensure battery voltage is greater
than 12 volts prior to and during pinpoint test.
Caution: Do not have a battery
charger attached during vehicle testing.
Warning: Never use electrical
test equipment on any circuit related to the SRS unless instructed by ...
Multi-Function Switch, Replace
Oil Pressure Switch R&R