Chevrolet Cobalt Service & Repair Manual: Pinpoint Test

Ensure battery voltage is greater than 12 volts prior to and during pinpoint test.
Caution: Do not have a battery charger attached during vehicle testing.
Warning: Never use electrical test equipment on any circuit related to the SRS unless instructed by the manufacturer. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.
1. Obtain manufacturer pinpoint test tables for vehicle system to be tested.
2. Obtain required manufacturer connector views for any electrical connectors involved in testing.
3. Following pinpoint test table, use a multimeter and/or 12V test light to test circuits as instructed. Manufacturer connector views will help identify color/number of wire circuits to be tested at connector.
4. Once issue has been located, correct issue and retest electrical system as outlined in "Retest System."
    Oil Pressure Switch R&R
    Refer to Fig. 1 when performing following procedure. 1. Disconnect battery ground cable. 2. Raise and support vehicle. ...

    Radio, Replace
    1. Remove accessory trim panel and disconnect electrical connectors. 2. Remove mounting screws and pull radio out. ...

    See also:

    Chevrolet Cobalt Service & Repair Manual. Wheel Hub & Bearing, Replace
    Rear Disc Brakes 1. Raise and support vehicle, then the tire and wheel assembly. 2. Without disconnecting the hydraulic brake flex hose, remove and support rear brake caliper and bracket as an assembly. ...

    Chevrolet Cobalt Owners Manual

    Chevrolet Cobalt Service Manual


    Copyright © 2024 www.cheviguide.com - Chevrolet Auto Manuals - 0.0047