Chevrolet Cobalt Service & Repair Manual: Suspension Control Arm Bushings R&R
Front
| Note depth and orientation of
old bushing before removal. |
| 1. |
Raise and support vehicle. |
| 2. |
Remove lower control arm. |
| 3. |
Wrap control arm with a shop towel
and place it in a vise. |
| 4. |
Remove control arm bushing from lower
control arm, using front control arm bushing set tool No. J-41211,
or equivalent, Fig. 1. |
| 5. |
Disassemble tools and remove bushing. |
| 6. |
Reverse procedure to install, noting
following: |
| |
a. |
Place NEW bushing to tapered side of
control arm. |
| |
b. |
Install control arm bushing in lower
control arm, using front control arm bushing set tool No. J-41211,
or equivalent. |
| |
c. |
Install bushing to same depth and orientation
as noted during removal. |
|
Fig. 1
Front
1.
Remove strut assembly upper mounting
nuts.
2.
Raise and support vehicle, then remove
tire and wheel assembly.
...
1.
Remove the strut upper mounting nuts,
Fig. 1.
2.
Raise and support the vehicle.
3.
Remove the tire and whe ...
See also:
Chevrolet Cobalt Owners Manual. Ashtray(s) and Cigarette Lighter
The vehicle may have an ashtray and cigarette lighter.
To use the lighter, located on the instrument panel
below the climate controls, push it in all the way and
let go. When it is ready, it will pop back out by itself.
Notice: Holding a cigarette lighter in while it is
heating will not allow t ...
Strut Assembly, Replace
Suspension Strut Mount Assembly R&R