Chevrolet Cobalt Service & Repair Manual: Windshield Washer Fluid Pump, Replace
| 1. |
Drain washer solvent from windshield
washer fluid reservoir into suitable clean container. |
| 2. |
Remove front fender liner as outlined
in "Front Fender Liner." |
| 3. |
Disconnect windshield washer pump electrical
connector, Fig. 1. |
| 4. |
Disconnect washer pump hose, Fig.
1. |
| 5. |
Remove washer pump from washer solvent
container using a suitable small flat bladed tool, Fig.
1. |
| 6. |
Remove seal from washer solvent container
using a suitable small flat bladed tool, Fig. 1. |
| 7. |
Reverse procedure to install. Press
seal and pump in place until fully seated. |
|
Fig. 1 Windshield washer fluid pump removal
Refer to Fig. 1
when performing following procedure.
1.
Remove door panel pull cup trim plate.
2.
Remove armrest pull cup.
...
1.
Disconnect washer hose clip at righthand
front fender flange.
2.
Disconnect washer pump hose from windshield
washer hose at righ ...
See also:
Chevrolet Cobalt Service & Repair Manual. Compression Pressure
When inspecting cylinder compression,
the engine should be at room temperature, the throttle should be open, the
spark plugs removed and the battery at full charge. The lowest reading cylinder
should not be less than 70% of the highest and no cylinder reading should
be less th ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Window Switch R&R
Windshield Washer Fluid Reservoir, Replace