Chevrolet Cobalt Service & Repair Manual: Blower Motor, Replace
| 1. |
Disconnect blower motor electrical
connector. |
| 2. |
Remove lower blower motor cover heat
stakes, Fig. 1, using small suitable chisel. |
| 3. |
Remove lower blower motor cover. |
| 4. |
Remove blower motor nuts. Fig.
2. |
| 5. |
Remove blower motor cup from lower
case by cutting through case between circular ribs, Fig.
3, around motor with a sharp utility knife. |
| 6. |
Release blower motor retaining tab,
then remove blower motor from cup. |
| 7. |
Reverse procedure to install. Torque
blower motor nuts to 21 inch lbs. |
|
Fig. 1 Blower motor cover heat stake locations
Fig. 2 Blower motor retaining nut locations & Motor replacement
Fig. 3 Cutting through case between circular ribs
1.
Disconnect blower motor resistor electrical
connector, Fig. 1.
2.
Unsnap blower motor resistor from HVAC
module, then remove res ...
1.
Open instrument panel glove compartment
door. Access door for cabin air filter is located behind glove compartment.
2.
Tilt instrument ...
See also:
Chevrolet Cobalt Service & Repair Manual. Hood Hinge
Removal
When a hood hold open device
is being removed or installed, provide alternate support to avoid possibility
of damage to vehicle or personal injury.
1.
Open hood.
2.
Place a suitable support between hood
and ...
Chevrolet Cobalt Owners Manual
Chevrolet Cobalt Service Manual
Blower Motor Resistor, Replace
Cabin Air Filter, Replace