Chevrolet Cobalt Owners Manual: Center High-Mounted Stoplamp (CHMSL)
To replace a CHMSL bulb: 1. Open the trunk.
2. Press the tabs to release the bulb assembly.
3. Pull the bulb assembly down to access the bulbs.
4. Pull the old bulb straight out.
5. Push the new bulb straight in until it clicks.
6. Align the tabs in the bulb assembly with the assembly in the trunk lid. Push the bulb assembly back into place until it snaps in. You may need to use a tool to guide the tabs into the assembly.
Headlamps, Front Turn Signal,
Sidemarker, and Parking Lamps
A. Front Turn Signal/Parking Lamp
B. Sidemarker
C. Headlamp
To replace one of these bulbs:
1. Open the hood. See Hood Release.
2. Remove the two bolts from the headlamp
assembly.
3. Remove ...
Taillamps and Turn Signal Lamps (Coupe)
To replace this bulb:
1. Open the trunk.
2. Remove the trunk trim and pull back fastener.
3. Disconnect the wiring harness by lifting up on the
tab to release and pull it straight out.
4. Turn ...
See also:
Chevrolet Cobalt Service & Repair Manual. Engine Valves R&R
Valve stem oil seal alignment
and position is critical. An improperly installed valve stem oil seal may
lead to excessive oil consumption, and increased vehicle emissions.
When replacing multiple valves
simultaneously, mark valves in relation to cylinder/port. Keep al ...
Chevrolet Cobalt Owners Manual
- In Brief
- Seats and Restraint System
- Features and Controls
- Instrument Panel
- Driving Your Vehicle
- Service and Appearance Care
- Maintenance Schedule
- Customer Assistance Information
Chevrolet Cobalt Service Manual
- Air Bags
- Air Conditioning & Heater
- Body & Frame
- Brakes
- Cooling System
- Driveline
- Electrical
- Electronic Stability Controls
- Engine Service
